Circuit Schematic Regulated Power Supply 0-28 VDC 6-8A using LM317 and 2N3055

PowerSupply. - This is electronic Circuit Schematic Regulated Power Supply 0-28 VDC 6-8A using LM317 and 2N3055 like in Figure 1 below. In this circuit schematic the basic component used are LM317 and 2N3055. 

In here we will give you global description about Circuit Schematic Regulated Power Supply 0-28 VDC 6-8A using LM317 and 2N3055 and then we will give you link to continue your reading from original source as external website.

Circuit Schematic

Component Part

  • Transformer
  • Resistors
  • Capacitors
  • LM317
  • Diodes
  • 2N3055
  • All components please see Figure 1. above
Description

Circuit schematic like in Figure 1 above is Circuit Schematic Atmel Solar Panel Battery Charger using ATTiny13VAccording Electronics-diy site describe that this is an easy to make power supply which has stable, clean and regulator 0-28V 6/8 Amp output voltage. By using two 2N3055 transistors we become more then 2 times the amount of amps then the power supply delivers, making it real though to brake ;). Although you could use this design to deliver 20 amps (with almost no modifications and with a proper transformer and a huge heat sink with a fan), I did not needed such much power. Make sure you mount them on a huge heat sink, as the 2N3055 transistors can get very hot at full load.

And now you can read more you knowledge about Circuit Schematic Regulated Power Supply 0-28 VDC 6-8A using LM317 and 2N3055 from the original source article using link [here].
Share on Google Plus
    Blogger Comment
    Facebook Comment

0 comments:

Post a Comment