Circuit Schematic DC Output Solid State Relay 10Amps 60V DC using TLP250/352 Optocoupler

Switching. - Here is electronic Circuit Schematic DC Output Solid State Relay 10Amps 60V DC using TLP250/352 Optocoupler like in Figure 1 below. In this circuit schematic the basic component used are IRFP260 and TLP250/352. 

In here we will give you global description about Circuit Schematic DC Output Solid State Relay 10Amps 60V DC using TLP250/352 Optocoupler and then we will give you link to continue your reading from original source as external website.

Circuit Schematic

Figure 1. Circuit Schematic DC Output Solid State Relay 10Amps 60V DC using TLP250/352 Optocoupler (Source: Electronics-lab)

Component Part

1. TLP250/350 Optocoupler
2. IRFP260 MOSFET
3. Resistors
4. Capacitors

Description

Circuit schematic like in Figure 1 above is Circuit Schematic DC Output Solid State Relay 10Amps 60V DC using TLP250/352 Optocoupler. Electronics-Lab site describe that his project has been designed around TLP250/352 which is Opto-Coupler IGBT/MOSFET Gate Driver from Toshiba and Mosfet IRFP260 from IR, This relay consists of optically isolated gate driver and low impedance Mosfet. The combination of low resistance and high load current handling capabilities make this Relay suitable for a variety of switching applications.  These devices are ideally suited for controlling high voltage and current DC loads with solid state reliability while providing 3750V isolation from input to output.

A solid-state relay (SSR) is an electronic switching device that switches on or off when a small external voltage is applied across its control terminals. SSRs consist of a Opto-isolator  which responds to an appropriate input (control signal), a solid-state electronic switching device which switches power to the load circuitry, and a coupling mechanism to enable the control signal to activate this switch without mechanical parts. This relay designed to switch DC Load up to 10Amps. It serves the same function as an electromechanical relay, but has no moving parts. Solid-state relays have fast switching speeds compared with electromechanical relays, and have no physical contacts to wear out. Input trigger voltage 3V to 9V DC (1.5V to 12 V with Transistor) and output load 10Amps and supply 12V to 60V DC (100V DC also Possible). Gate Driver required supply 12V to 18V DC. Heat sink required for peak load.

And now you can read more you knowledge about Circuit Schematic DC Output Solid State Relay 10Amps 60V DC using TLP250/352 Optocoupler from the original source article using link [here].

Thank you for your coming here in Electronic Index blog, we hope the article above will help you to know more about your an electronic circuit schematic design and simulation and other. Please comment here when you want to share and other. Thank you.

Share on Google Plus